loading
Multi Modular Cable Tester NS-468B

    Multi Modular Cable Tester NS-468B

    RM 48.00

    Please select option below

    X

    Quantity
    - +
    1 left
    Delivery From Selangor
    Estimated Arrival : 1-3 working days.
    Shipping Fee
    RM 7 by courier to Peninsular Malaysia
    RM 22 by courier to Sabah, Labuan
    RM 22 by courier to Sarawak
    RM 200 by courier to Oversea
    Ship To : International
    ADD TO CART
    BUY NOW
    Add to wishlist
    Product ID : 222337468 Brand : NO BRAND Model / SKU : NS-468B Conditions : New


    Multi Modular Cable Tester NS-468B

    Multi Modular Cable Tester NS-468B


    Multi Modular Cable Tester NS-468B


    Multi Modular Cable Tester NS-468B

    NOTED : For more units do chat us before purchase. Thanks

    The NS-468 is a cable tester for checking LAN network cables. It is a 2-in-1 multi-testing tool capable of testing network and phone cables. It has sockets for testing RJ11 and RJ45 modular jack connections and tests for the T568B and T568A wiring schemes. It consists of two parts, the remote and a master. It does not arrive in a box; however, the manufacturer provides a zip case for storage, and a small half-sheet of paper for the instruction manual.

    How to use Instructions
    The circuit uses a decade counter chip, which tests the condition of each electrical connection and lights a green LED when the connection is good. If you are testing a CAT5 or CAT6 network cable terminated with a RJ45 modular connector, then you connect one end of the wire to the master unit and the other end to the remote unit. Slide the power switch to S for a slow automatic test, where each of the nine LED lights in sequence from 1 to G on both the master and remote units. When an LED fails to light, it indicates a fault with the pin connection associated with it.

    When an LED in the sequence does not light, that indicates an open circuit fault. If however, the wrong LED lights, then that is a short circuit fault.

    According to the instruction manual, LED 1 through to LED G should light green sequentially on the master unit and on the remote unit, when testing RJ45 connections.

    When testing RJ11 connections LED 2, LED 3, and LED 4 should light on the remote unit. If your tester is the version with BNC testing capability, then LED 1 and LED 2 should light.

    Master and Remote
    For long wires where the ends are less than 1000 ft away from each other, the remote part and the master part are conveniently separable. This is very useful where you have a long network wire that terminates in different rooms.

    ** There is 1-3cm errors due to manual measurement. Please kindly understand.
    ** Actual product colour may slightly vary due to photographic lighting sources or your monitor settings.
    ** PRICE INDICATED IS ALREADY BEST PRICE, EXCLUDE COURIER




    Average Product Rating

    0.0 stars out of 5
    5 star
    0
    4 star
    0
    3 star
    0
    2 star
    0
    1 star
    0
    Share your thoughts with others
    Write a review
    Only buyers who purchased the product may leave a review



    Information
    Copyright © 2024. All rights reserved | www.ecomtb.com.my | Powered by Webstorepro.my
    ECOBUILD HARDWARE - TAN MERE LEE 001871965-H